Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone, We have Call Manager 8.5.1 and it is currently configured for sites that has DID on each Cisco IP Phones. I am getting ready to open Call Manager to a site that is currently configured a little different than the others. Current...
I had to use a FXO card to interface with the Viking C-1000B and W3000 Door Buzzer.On the router with FXO card:voice-port 0/1/0connection plar 1100 <==number to ring when someone buzzes in.description Door Buzzerstation-id Door Buzzervoice-port 0/1/1...
Hello, I am in the same situation as you. But a little less farther. I have a Viking 1000B and W3000 system. When I connect an analog phone line on the pin 4 and 5 of the Viking 1000B the phone rings. But when I connect it to an ATA, the line 1 i...
Hello Rob, I have the exact setup like what you mentioned above. I have a W3000 and C-1000B. I was told by Viking that I cannot set up an ATA with this device because the ATA will not work with W3000. In addition, they told me I need a FXO...
Arun, I am getting an idea on how to implement it. Thanks. A few more questions for clarification (based on your example). I will need to configure hunt pilot 2000 and point all 10 incoming lines numbers to that number. Then create a hunt gro...
First of all thank you very much for replying, Arun. First of all i'm not sure why you're using DID, If all the 10 lines are answered by a receptionist. I mentioned DID because currently we have 10 POTS lines setup on the receptionist phone and I w...
