Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About daniel.morales.sk
Stats
Member since
05-10-2012
15
Posts
0
Helpful
0
Solutions
Created by
daniel.morales.
in Voice Systems
in Voice Systems
01-23-2014
06:35 AM
01-23-2014
06:35 AM
El esquema de conexión para el servidor de VoIP consta de CUCM conectado a un Gateway (Router) que realizara las funciones de CUBE (Cisco Unified Border Element) para que pueda conectarse con 5 Proveedores SIP mediante SIP Trunks, la duda que se tiene en la imagen en el recuadro rojo es que la comunicación entre el CUCM y el CUBE debe ser mediante un SIP Trunk o un Trunk H.323? Cuál seria el mas recomedable y por qué? El CUCM va a funcionar para 5 diferentes empresas en un mismo lugar, por ejemplo: Empresa 1: Extensiones 1XX Empresa2: Extensiones 2XX Empresa3: Extensiones 3XX Empresa4: Estensiones 4XX Empresa5: Estensiones 5XX La conexión hacia la PSTN se realizara mediante 5 Proveedores SIP, un Proveedor SIP para cada empresa, la duda que se presenta es como direccionar las llamadas, por ejemplo la empresa 1 envié todas las llamadas por el Proveedor SIP1, la empresa 2 envié todas las llamadas por el proveedor SIP2 y de igual forma el ingreso de llamadas por el Proveedor SIP1 se envie a la empresa1 (1XX), no estoy seguro si esto se puede realizar con Route List y Route Groups? o con que lo puedo realizar?
... View more
Labels:
10-01-2013
02:15 PM
Hello, I have the following Switches: WS-C2960S-24TD-L and WS-C2960S-24PS-L can perform FlexStack between these models? or must be the same type of switch for the Stack?
... View more
Labels:
08-14-2012
07:26 AM
On the schedule we have, if at sites of remote has a FXO, this call can be redirected to the central office? or need another UC5XXpara able to do this?
... View more
Created by
daniel.morales.
in Voice Systems
08-13-2012
01:11 PM
08-13-2012
01:11 PM
There is some kind of information regarding these settings that we can review?
... View more
Created by
daniel.morales.
in Voice Systems
08-13-2012
09:23 AM
08-13-2012
09:23 AM
The configuration would be the same as when integrated with other UC5XX by dial peers? Or should I set any additional options?
... View more
Created by
daniel.morales.
in Voice Systems
08-13-2012
08:59 AM
08-13-2012
08:59 AM
It would be possible to configure SIP Trunk with UC560 and Alcatel-Lucent OmniPCX Enterprise?, Or configure a SIP trunk between UC560 and Lync Server?
... View more
Labels:
08-10-2012
07:10 AM
Hi David, In short you do not recommend this type of scenario using a UC320? It is true that the UC320 has no CLI, but through the VPN site to site will be able to register the physical phone? Any other limitation that has the phone for SPA families, besides the voice quality?
... View more
08-09-2012
12:45 PM
I have a question... On the same scheme described above, instead of using a UC540, UC320 would be used one, it would likely through VPN site to site can register the phone to remote sites?
... View more
08-09-2012
12:41 PM
Please let me know which is a limiting SPA300 phones to use in remote sites?
... View more
08-09-2012
11:00 AM
In some special phone model you would recommend to place it at the remote site?
... View more
08-09-2012
10:43 AM
Would have no problem with physical models of phones, for example if I use the phone SPA303 or SPA502, these phones were registered through the vpn site to site in the uc540?
... View more
08-09-2012
09:54 AM
initially could make a vpn site to site with the SR520 router, and physical phone so you can register from remote sites, but this router is in EOL, and its replacement is the CISCO867VAE-K9, with the 881 router I can do the same scenario?
... View more
08-09-2012
09:26 AM
we have a UC540 at the main office, and a router 881 in a remote office. We perform a Site to Site VPN between the office and remote site in which physical phone installed. Is this scenario possible? or need for physical phones at the remote site to register on my uc540 central office? another scenario would be to use two ROUTERS 881 both the central office to the remote site and perform a site to site VPN, the uc540 would be found behind the router 881.
... View more
Labels:
Created by
daniel.morales.sk
in Voice Systems
01-23-2014
01-23-2014
El esquema de conexión para el servidor de VoIP consta de CUCM conectado
a un Gateway (Router) que r...
10-01-2013
Hello,I have the following Switches: WS-C2960S-24TD-L and
WS-C2960S-24PS-L can perform FlexStack bet...
08-14-2012
On the schedule we have, if at sites of remote has a FXO, this call can
be redirected to the central...
08-13-2012
The configuration would be the same as when integrated with other UC5XX
by dial peers? Or should I s...
08-13-2012
It would be possible to configure SIP Trunk with UC560 and
Alcatel-Lucent OmniPCX Enterprise?, Or co...
08-10-2012
Hi David,In short you do not recommend this type of scenario using a
UC320? It is true that the UC32...
08-09-2012
I have a question...On the same scheme described above, instead of using
a UC540, UC320 would be use...
08-09-2012
Would have no problem with physical models of phones, for example if I
use the phone SPA303 or SPA50...
08-09-2012
initially could make a vpn site to site with the SR520 router, and
physical phone so you can registe...
Public Statistics
| Date Registered | 05-10-2012 07:48 AM |
| Date Last Visited | 03-24-2019 10:31 AM |
| Total Messages Posted | 15 |
.jpg "Hall of Fame Cisco Employee"){kind=icon}
