Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have cisco ASA 5510 and am using ASDMI am new to ASA and am trying t understand on what to do for the below 1. I have public ip 4.79.205.89 ---------> FW------> 192.168.10.1 ( Apool interface )for this to work would i need an Access rule and NAT ...
Hi,I am new to cisco routers and am trying to understnd the NAT rulesHow do i interpret this NAT exempt rule what will it do ? how is it different from static and dynamic NAT ruleAction:ExemptInterface: APOOLSource: 192.168.30.119destinition:10.100.2...
I am New to cisco ASA and would like to understand about Access rule basically i would like to know what does below do actually how do i read the belowis it like on interface outside , anyone comming from outside world on this outside inteface and ...
I believe the command "clear config threat-detection" will disable all the thread detection on the firewallIf it diables how do i enable the threat detection agaian-Nimika
How do i free memory on cisco asa 5510 below is the details of memory allocationsResult of the command: "show mem detail"Free memory: 54483928 bytes (20%)Used memory: Allocated memory in use: 128787496 bytes (48%) Rese...
Hi Here is the show versionResult of the command: "show version"Cisco Adaptive Security Appliance Software Version 8.2(1) Device Manager Version 6.2(5)Compiled on Tue 05-May-09 22:45 by buildersSystem image file is "disk0:/asa821-k8.bin"Config file a...
Here are the results of the commandResult of the command: "show run nat"nat (external) 0 access-list external_nat0_outboundnat (APOOL) 0 access-list nonatnat (APOOL) 10 0.0.0.0 0.0.0.0nat (SPOOL) 0 access-list ALE_Test_nat0_outboundnat (SPOOL) 10 0.0...
It was working fine for last 1 year recently we did move the Cisco adaptor due to Hardware migration to new setup after that we have been seeing this issueThanks
