01-03-2014 02:04 PM - edited 03-11-2019 08:24 PM
I am New to cisco ASA and would like to understand about Access rule basically i would like to know what does below do actually how do i read the below
is it like on interface outside , anyone comming from outside world on this outside inteface and going to destinition pool should be allowed
thats how i should read it ?
interface: outside
Action:permit
Source:any
Destinition:<obj_pool>
Service:tcp/https
01-03-2014 02:09 PM
Hi,
I guess you mean the ASDM version rather than the actual ASA software?
Sadly I dont use ASDM to configure ASA firewalls at all.
But to me it seems that the above just means that
On the CLI of the ASA you can use the following command to list all the ACL / Access List configurations
show run access-list
With the following command you can view what ACLs / Access Lists are connected to which interfaces on the ASA
show run access-group
- Jouni
01-04-2014 05:48 AM
Hi Sagar,
Your understanding is correct and it's commonly termed "inbound" traffic.
That is, traffic sourced from lower security arriving to a higher security level. The "outbound" traffic would just be the reverse
For the example given, it means that any traffic from outside (usually Internet traffic), with source TCP port 443/HTTPS, will be allowed to communicate to the object pool/alias that was defined.
Sent from Cisco Technical Support iPhone App
01-08-2014 12:08 PM
Thankyou
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide