About rsfrank

rsfrank · 02-02-2014

I have a switch that I have configured with a voice vlan. I would like to use WAN 1 as the primary for voice and have other network traffic use WAN 2 for its primary and have both sets of traffic failover if either connection goes down. It this even ...

rsfrank · 02-02-2014

I am trying to setup these routers to basically take voice traffic and have it use one of the two WAN connections as it's primary and all other traffic use the other connection. I would like it so that if either connection fails they also failover be...

rsfrank · 02-04-2014

Thank-you for the help. The Device arrives for me in the next day or two. I'll post back here if I run into any issues but I suspect from what you've written this should be pretty smooth!Thanks again for the help!-Rod

rsfrank · 02-04-2014

Thank-you for this. So I would assume this would work as well if instead of protocol I used subnet based binding? With the voice vLAN it is all on a different subnet so I was thinking to use this vs. trying to figure out the Protocol Binding.Thanks...

Member Since	‎02-02-2014 07:56 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	4

User Statistics

User Activity

RV 320 / 325 Dual WAN question

RV320 / 325 Dual WAN Question

RV320 / 325 Dual WAN Question

RV320 / 325 Dual WAN Question