Good day, Can i disable signature for one host ? (not suppression) Thanks. ... View more

Hi there,  I have configured 5525x with cluster and its failed with below error message "The master unit has disabled clustering because of a Security Service Card health check failure" Whats wrong with that ? thanks ... View more

i have configured netflow in my router but my router is overheaded. So i decided to configure sampled netflow and sampling rate of 1 out of 100 packets may reduce the export if Netflow data by as musch as 50 percent.So you know its not suitable for security monitoring. Whats your recommendation ? is there any solution on collector? ... View more

Hi there,  1.After i configure netflow in my router , which method (sampled vs unsampled ) will we use ( I mean whats the default method ?  ) ?  2.How do i configure unsampled (1:1) netflow ?  thanks  ... View more

Hi folks ,  I am planning to make asa 5545-x cluster.So i have some question. Question is : 1.Which mode(spanned or invidivual) should i use ? 2.What is your recommendation ? I implemeneted as A/S before. But there was high CPU usage issue cause of Connection per second is high Here is topology: ... View more

Hi there.  i really confused with my intrusion policy block below signature. I dont know what is 1 instances of http - drop ... View more

Hi folks ,  Can i decrease UDP connection  timeout less than 1 minute?  I want to change all udp packet timeout to 30sec. Thanks . ... View more

Hi community ,  there is no data on firesight . How can i solve this ?  on ASA : show service-policy sfr Global policy: Service-policy: global_policy Class-map: sfr SFR: card status Up, mode fail-open packet input 25687, packet output 25687, drop 0, reset-drop 0 ... View more

hi is there any way to track priviliged command (shutdown so on) ?  ... View more