About Marat Rafikov

Marat Rafikov · 05-07-2015

Hi everyone!we are have a problem with enabling vc on EoMPLS circuit on Cisco ME3600x. all configuration is the same and working, we are checked ping, traceroute, ping mpls ipv4, ping mpls pseudowire, every our trying was clear and well, but when we ...

Marat Rafikov · 02-09-2014

hallo every one!i need setup vpls between two CPT 600 and can ping between 2 me3600 switchesbetween cpt 600 i was setup ospf and mpls and setup vpls, but my me3600 switch can not pingwhat i do wrong?my topology in attachmentthis is my hardware config...

Marat Rafikov · 05-07-2015

when i configure pw-class i cant add "ip local interface loo 0" on both side, because in my equipments does not present this commandin this time i have this configuration on the both side:KAND_sw1#sh run | b psepseudowire-class eompls encapsulation m...

Marat Rafikov · 05-07-2015

in our cisco ME3600x local interface is interface VLAN 1517.KAND_sw1#sh inter vl 1517Vlan1517 is up, line protocol is up Hardware is EtherSVI, address is 78da.6ead.7a40 (bia 78da.6ead.7a40) MTU 9212 bytes, BW 1000000 Kbit/sec, DLY 10 usec, re...

Marat Rafikov · 05-07-2015

hican you please tell me what kind of configuration you want to see?and second, can you please explain to me which local interface i need to check?

Marat Rafikov · 05-07-2015

hithis option is still not support (((

Marat Rafikov · 06-30-2014

hi!i have same a problem. but if use I/O Mode 2 or Mode 3 i cant enable mpls functions on tengig ports. can you tell me, what i need to do for usage 4 tengig ports and usage in this port mpls functions

Member Since	‎02-08-2014 10:47 PM
Date Last Visited	‎08-29-2018 12:01 AM
Posts	9
Total Helpful Votes Received	5

User Statistics

User Activity

L2VPN EoMPLS status down on ME3600x

vpls configurations on cpt 600

when i configure pw-class i

in our cisco ME3600x local

hican you please tell me what

hithis option is still not

hi!i have same a problem. but