Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I could use some help here for the following problem.
We have a 2901 voice trunk from our ISP,and use a BVI interface with ip 192.168.100.1 255.255.255.248 connected to our IPBX, here lies the issue,when these are back to back connect...
Hello everyone,i would like your input on which way to go on the following task
Vlan10 Data
Vlan20 Voice
Vlan 30 Guest
Vlan 90 Management
I will post my switch config so you can see what i have done so far,and also take note that i have created all t...
Hello,
I have a 1921 with ''c1900-universalk9-mz.SPA.150-1.M4.bin '' + securityk9 license doing pppoe ,nat, zbf, and im getting these strange logs on ppp negotiation after the connection has been established,here is a sample,and this is going on for...
Hello sirs,Im new to this so please forgive my ignorance,i have a cisco 876 router running advipservicesk9-mz.124-15.T17 ios,my adsl2+ line is Pstn so i figured i could use this router with a zyxel modem in bridged mode,after much frustration and sea...
Thank you very much for your input,i want to go with Firewall solution and keep everything on it, i will be using a 100D because 60D does not support LACP for the 100 port issue you mentioned and you are right it will be a problem
Hello gpauwen
So this must be coming from my isp correct?
I mean i use a dynamic ip address and it has changed many times but this log is always there so
Kerberos#conf tEnter configuration commands, one per line. End with CNTL/Z.Kerberos(config)#intKerberos(config)#interface faKerberos(config)#interface fastEthernet 0Kerberos(config-if)#no swKerberos(config-if)#no switchport% Incomplete command.if i ...
