Thanks Jon, got a question on step 3. Not sure on how to create a SVI and migrate the IP. Is this what you are talking about? Interface vlan 955 ip address 192.168.18.1 255.255.255.252 Then on the switchport interface fastethernet 4/0/1 switchport trunk allowed vlan 955 switchport mode trunk And then keep the static route the same?
... View more
Hi I have an issue where I have two sites that we are trying to connect via an ethernet port. In site 2 I am using the gig0/0 port on a 1941 router and configured the port as such: interface gig0/0 ip address 192.168.18.2 255.255.255.252 ip route 10.0.4.0 255.255.255.0 192.168.18.1 site 2, I am using a 3750 switch because I don't have any gig ports available on their router and is configured as such: interface FastEthernet4/0/1 no switchport ip address 192.168.18.1 255.255.255.252 ip route 172.20.0.0 255.255.0.0 192.168.18.2 Although both ports show up as up and I can ping their interfaces locally, I cannot ping the far side interfaces nor their networks. I've tried changed the gateway to the local interface but that didn't work either. The carrier claims I need to have it on a vlan and suggested this config on site 1: Interface gig0/0.955 encapsulation dot1q 955 ip address 192.168.18.2 255.255.252 And there is the problem. I cannot configure a sub-interface on the L3 switch and cannot add the vlan like they recommend. Any suggestions from anyone on how to connect the two sites? Thanks
... View more