About manojkumard

manojkumard · 03-04-2014

Hi,I have WS-C2950-24 switch... Last night i have noticed an issue in it.. Switch is reachble but unable to telnet to the switch.While i login through console... i was getting LOW ON MEMORY TRY AGAIN LATER...After i have harf rebooted the switch (Pow...

manojkumard · 02-23-2014

I'm unable to create or remove any VLAN on my cisco switch...C2950 Software (C2950-I6K2L2Q4-M), Version 12.1(22)EA6Error:APP-SW-LAN-CISCO-#5(config)#no vlan 10 Error on initialize VLAN database 1: VTP feature not yet initializedwhen i give "show run"...

manojkumard · 02-19-2014

Hi,Can any one explain about Routed and transperant mode on Cisco ASA in a simple words..

manojkumard · 02-18-2014

Hi,I have two WAN routers where two different ISP were terminating on the router and both the routers were connected to the Firewall through unmanageable switch as a mediator.Also, I have two IANA subnet (ex. 1.1.1.0/24 & 2.2.2.0/24), where 1.1.1.1 i...

manojkumard · 03-04-2014

Attached the screen-shot..

manojkumard · 02-21-2014

Thanks for your reply....But if i run BGP also,it wont be effective.. becoz.. We have 2 default gateway (1.1.1.1 & 2.2.2.1) pointing to two different routers... So, if we ru n BGP also, If primary link goes down (1.1.1.1), incoming traffic will come ...

manojkumard · 02-20-2014

But, Why we require two different mode like Rotue and Transperant mode.. What is the use of it...

Member Since	‎02-18-2014 08:59 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	7

User Statistics

User Activity

Boot Process failed on Cisco Switch

Unable to create or remove VLAN

Difference between Routed and Transperant mode on firewall

Redundancy on WAN link

Boot Process failed on Cisco Switch

Redundancy on WAN link

Difference between Routed and Transperant mode on firewall