About tk lam

tk lam · 08-03-2018

Hi, is there any way to setup rv130 vpn to connect the mobile, pptp ok for android, however, not available on iphone, and is this ok the setup ipsec to connect the mobile and how?

tk lam · 01-03-2017

RV042G using dual wan and would like to open a port# (eg.1234) on WAN2 set Firewall->Access Rules-> Action=Allow, Service=Port#1234, Interface=WAN2, Source=Any, Destination=device IP, Time=Always set Setup->Forwarding-> port1234[tcp/1234~1234]->devic...

tk lam · 08-16-2016

I did try to use RV180 or RV042G to setup quickvpn, but dont know why after "verifying network... ", it shown "the remote gateway is not responding. do you want to wait?"

tk lam · 03-07-2016

TunnelGroup VPNTunnel No. 13Tunnel Name : testclientInterface : WAN1Enable : yes Local Group SetupLocal Security Gateway Type : IP onlyIP Address : (WAN IP address)Local Security Group Type : SubnetIP Address : 192.168.11.0Subnet Mask : 255.255.255.0...

tk lam · 06-05-2015

HI,RV220WINT: 192.168.20.x/24RV042GINT: 192.168.70.x/24VPN connection established, we can see both internal devices through both networkhowever, we would like to set up a device in 70 network as 20 deviceeg. a new server setup on a 70 network, the IP...

tk lam · 01-06-2017

I have VOIP system running on WAN1, the other just normal port forward on WAN1 and i did make sure WAN2 port forward is ok problem if i am not using dual WAN router

tk lam · 01-05-2017

I'm using load balance after open this rule "set Setup->Forwarding-> port1234[tcp/1234~1234]->device pc [enable]" we can connect this port with WAN1 network and its working, but I want it to use on WAN2 network only follow your step to deny this por...

tk lam · 08-18-2016

Thanks for your advise I change the setting to group VPN when I try to connect on ShrewVPN the tunnel is actually "Connected", but after 30 sec "negotiation timeout occurred" and disconnected, so i still not able to connect WAN network -> Huawei B2...

tk lam · 01-08-2015

did you enable the rdp in the windows firewallmake sure it enable in the pc then thr router

tk lam · 08-27-2014

Hi, I did try to set in Bandwidth ManagementType: priorityInterface WAN1Direction: UpstreamPrority: HighEnablebut when I select load balance the IP will change it to WAN2 ext IP, and this service seem like not working, but I changed it to use WAN1 as...

Member Since	‎02-14-2014 07:44 AM
Date Last Visited	‎09-21-2018 10:42 AM
Posts	22

User Statistics

User Activity

RV130 vpn to android phone and iphone

RV042G dual wan specific port on WAN1 or WAN2

RV042G quickvpn issue

RV042G setup client to gateway problem

rv042g & rv220w vpn + vlan problem

I have VOIP system running on

I'm using load balance

Thanks for your advise

did you enable the rdp in the

Hi, I did try to set in