Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community, Can you advise if upgrade process of ASR9006 from 5.x to 6.x is any different to the upgrade of 9001? I'm wondering especially regarding the dual RP in 9006. Is there any official pdf from Cisco for dual RP? Thanks.
Hi Community, Question about possibility to copy a file between two ASR devices - is it supported? If so then lets say i have a file asr-new-software.tar on harddisk: and now how the scp line should look like?When I try the below one it does not seem...
Hi, I'm working on upgrading ASR from 5.3.3 to 6.3.3. I've tested this upgrade in the lab and it was very straight forward upgrade. However in production i'm getting some errors.I did install add with the tar file that went ok and now the activation ...
I have an existing policy-map with vip and port 80. Now I need to do:1. Match pool of ip address and url /abc then redirect to url /abc12. If url is ok but ip is out of the pool then redirect to url /abc2It's probably possible to achieve but I have p...
Hi Tkarnani, Thank you. When there are two RPs what happens when i will do install add and install activate - both will reload at the same time? Or only the active one will reload and system will switch to the second RP?
Hi Yep I have both of those you mentioned: disk0:asr9k-asr901-nV-px-5.3.3disk0:asr9k-9000v-nV-px-5.3.3 Node 0/RSP0/CPU0 [RP] [SDR: Owner]Boot Device: disk0:Boot Image: /disk0/asr9k-os-mbi-5.3.3/0x100000/mbiasr9k-rp.vmActive Packages:disk0:asr9k-serv...
Hi Kanwal, it looks ok. Thank you,In this configuration is it possible to somehow secure the serverfarm which redirects to url /abc1 from someone who will try entering http://myserver/abc1 directly?
