Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I purchased a student version of the VIRL and I want to install it on a Laptop that has 5i CPU with 8GB RAM. I did a run install initially but I notice that I am not getting an IP address or the network card is not being recognized. Now the...
Hello there,I have attached my lab. I created vlan 10 and 20 using a core switch and assigned the end workstation to their vlan ports. I am putting a border router and I want the laptops in vlan 10 and 20 to access the IP address 192.168.1.2.The idea...
Hello there, I have core switch 6509 and access switches. On the 6509 switches I have created SVIs - different subnets and I have access Layer 2 switches on the floors. I have allowed traffice 1-100 on the trunk links.I have a new host with IIS servi...
Hello there,I have a DSL connection and it is connected to a small router that provides DHCP to clients. I was doing a lab at home and I connected one port from the small router and plugged it to a fa1/0/1 port on cisco switch 3750 and configured tha...
HelloI have a campus size network with C6509 as a layer 3 switch and all the access switches are layer 2 switches. I have defined all the SVIs and VLANs in both the Core and access switches. I have noticed that end devices that have default gateway p...
Sorry, if this was an enterprise and the core is the main layer 3 switch i can not do that. These SVIs serve wide number of users and i can not remove them.can I still do the router on stick in the router with out removing the SVI in the core ?
Sorry, I can not do what you are asking me.This is a campus network design.The intent is to have those laptops vlan 10 and 20 access 192.168.1.2 which could be an IP that is used by FTP server.What if R1 is replaced by PIX firewall or ASA will that w...
Thank you Paul and InayathUlla,I was able to allow the vlan on the trunk and the pinging from one switch to another switch is working fine but I am not able to ping from the laptop commad prompt to the other laptop.I am not sure what is the issue her...
Do I have to allow the vlan in the trunk? even though I want to put an access-list to allow few hosts to access that ip in vlan 102. The reason I am asking i have campus wide network and my vlans are separated in between the office and manufacturing....
I have asked these contractors to check the terminal network configuration and put the gateway. As of now The 6509 can ping the device but other access switches can not ping it and the clients in other subnets will not ping it. Thank you for re-assur...
