Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,If I have configure two interface with same security level, and run the command "same security-level permit inter interface" , then if any traffic is going in between the same security level interfaces ASA will maintain the state table or not.
Hi, I have a wlc 5508 and ISE, all users are authenticating on captive portal , If any user goes outside from premises/ wifi coverage got disconnect and Wifi asks for authentication again.Can we store users session for minimum 8 Hours to avoid login ...
Hi, When i configure 8.2 in trasparent mode and deploy the a network that was wrok on EIGRP after that i found the neighborship was stop when i allow the mutlicast address and prtocol on outside interface it was start the working But when i deploy an...
Hi Poonam, When we assign Mgmt IP address of transparent mode in 8.2 and BVI interface IP in 8.4 after that we see that ARP packet is allow its EtherType 0x806 and IP packet is also allow EtherType 0x800 without any ACL. As per you it is not allowe...