Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, my customer is replacing a pair of 3750 core switches with sx550x-16ft switches. we want the config to be as close as possible to today’s config, are there any automatic config converters available please? If not automatic, any idea how to manu...
Hi You lot, I'm sure I have inherited the flakiest of flaky ASA 5525 running 9.10 because I had the problem last week of a VPN that wouldn't work on both of it's interesting local hosts until I put it through the packet tracer.Today's problem again c...
Our IKEv2 VPN is showing some very odd behavior. We have two devices our end that need to be seen as interesting traffic, they are n.n.8.4 and n.n.9.4. When these were configured I put in 8.4 first followed by the 9.4, the tunnel came up, traffic pas...
So the scenario is that we have an exchange server with one leg on the Inside interface (my DMZ) and I want to NAT that to one of my public range of addresses. These are nnn.nn.n.232/29. The ISP has .233, the ASA outside interface is .234 and I wan...
I’m trying to set up an ASA as the main firewall for a charity organisation I volunteer for.I have been given a /29 address by the ISP and have obscured it just for security, in real life only the last octet is the same. X.x.x.40/29 with the router f...
Thanks Flavio, It's a factually correct answer, however doesn't really help me. I have a config wriiten in CLI for IOS, I need a conversion tool or someone who can say "Just do X, Y and Z"
Harvey, No idea why it worked, but it did. I'd run it through the CLI packet tracer many times, but twice through the ASDM PT and it burst into life. You sir are a genius..... Tim
