Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone using the C9500 as a core switch with stackwise virtual and ISSU upgrade capability.Would be looking to do as a Meraki managed config.I see it shows Meraki support 9500's and ISSU. Anyone actually doing that in production yet?Greg
I have 2 of these in production. Cisco C9500-12Q-A Catalyst 9500 12-Port 40GAre they going to be supported for Meraki sh cloud managed? I see 2 other models that are in the 9500 range on the list in the beta software now...Thanks,Greg
I have a few c9300's converted to cloud managed running 17.18.1I've been playing around in my dev environment by adding, subtracting to a stack or two. Switching from 8 in a stack to 4 in 2 stacks etc.I've noticed that the switches are still numbere...
C9300's sometimes don't display their modules in manangement console.Seems to happen with any browser.Is this common?I have to refresh and then sometimes they show properly.Meraki working on a solution?
I have some MR52's and MR44 and MR46.I have selected the latest released version MR31.1.6The 44 and 46's do the upgrade. The 52's I don't think actually do the upgrade since I think they only support a 30.x version.Anyway, my question is this: If I...
Good. I'm just noticing that the new 2nd switch stack I created from the larger stack I split, has the switch port numbers in it's config as 5/0/1 for example instead of 1/0/1.So when I look for them in the list they show up not exactly the way I wo...
So these are full cloud native mode. 4 are brand new directly from Meraki, while the others are existing C9300's that I have on hand. I actually have 15 of the C9300-48P that curently are in prouction. I will be converting those from cisco CLI only...
Yes I already know that. My question is not that. I have a mixed environment. Some MR52 and som MR46 in dfferent buildings of the same network.I need to know if I the MR52 will go up to its maximum firmware automatically if I have it assigned to a ...
