Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All: What steps do I need for the below scenario to happen. I want to have a site to site connection but instead of having private addresses via the tunnel I will have one side have a private address being natted via static nat and then that stati...
Hi Guys:
I am configuring the Virtual Defense center but i have two interfaces eth0 and eth1. If I run the script with this command:
sudo /usr/local/sf/bin/configure-network i notice it puts its own vlan id and it uses eth0.
my question would be
...
Hi: Thanks for the feedback. Am familiar with that configuration but my question was. How if the interesting traffic that goes in the tunnel is a public Ip address instead? How would that work?
Hi:
how will it be done if my internal network a /24 (being natted too) needs to reach to a outside destination with regular port 22 but traffic coming back from outside to my internal network (the natted address) which now will communicate to one of...
Thanks for your input. So the current behavior from your experience would be best. My current situation is I have 2 10G interface and the cost is the same by default so its "load balancing" but with the default behavior from what i have read here wit...
