Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a topology with a couple switches separated by a few routers, working within a practice lab in Web-UI of GNS3.On both switches, I configured the interfaces leading to the routers as trunk ports using dot1Q encapsulation. I also set both to the...
I am slowly acquiring a home lab of Cisco devices. I am currently studying for the CCENT, so Packet Tracer is working fine. But, I would like to have a few Cisco devices by the time I pass and start studying for the CCNA - Routing and Switching. I wi...
Thanks Tyson for that information. I was able to successfully configure it pretty quickly on just the LAN side, so that's as far as I'll go with labbing with VTP. I just saw it on the CCNA blueprint and wanted to mess around with it. I'm not studying...
Thank you everyone for the replies. I didn't realize you needed a special switching module in routers to accomplish this.In the real world, how are VLANS created in an organization with several branches in different cities? I assume VTP is not used a...
