Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I hope someone can assist me on this one. I migrated my home Cisco lightweight network from a physical 2504 WLC to a virtual 9800 CL WLC 17.2.1 with a 3802e running flexconnect and a catalyst 1920 ap centrally switched. I put together and...
i'm testing a vWLC running 8.10.121.0 with an AP3802e. The AP has been statically configured with an IP address for both itself and to point to the wireless controller. Does anyone have any ideas as to what could cause this? Thanks. capwap ap primar...
Hi All, I'm looking for an architecture recommendation to segment Guest LAN connected traffic located on the inside of the network with ISE offering guest hotspot portal. We currently have a guest anchor/dmz setup with ISE guest hotspot working fine....
Just purchased an ASA 5506-x with TAMC firepower license. The license came preinstalled and configured by the vendor. The problem I am having is that when I try configuring an access control policy with instrusion and AMP it complains that I don't ha...
Ever since deploying ISE 2.4 patch 9 with ASA to offer AnyConnect RAVPN services to BYOD users by checking against MDM/AirWatch for AD group membership and AirWatch device registration status we have had continuous issues with ISE reporting DeviceReg...
That did the trick :). Thanks so much for everyone's input and feedback. I setup a pretty cool infrastructure at home to stay on top of current technology and make recommendations. I have to understand that I cant expect the theoretical throughput. T...
Thanks Scott. I will try this. I just upgraded my Spectrum internet service to their 400meg internet speed. Attached are results from an 802.11ax and ac client. I'm getting the full throughput which is awesome. Its just that i'm expecting more betwee...
Here are the results with only 1 wireless client connected and an iperf test to a wired client. vwlc01#show wireless client mac-address f8e4.e3cb.be7a detail | in dBm|RateCurrent Rate : 13.5Supported Rates : 6.0,18.0,36.0,48.0,54.0Radio Signal Streng...
Thank you for the feedback. I will try this and report back the results as soon as I can. Do you have any experiences with running ISE services such as posture, guest services(hotspot, sponsored, self registered), etc with wireless using Flexconnect...
