About eclipse2000

eclipse2000 · 01-24-2012

Hi, Im quite new to all Cisco gear so i just want to check a few things before we proceed with our idea.We currently have a main network running through a static broadband connecting using a Cisco 1700 ADSL router, everything is working fine locally....

eclipse2000 · 12-19-2011

Hi guys, Im a little stuck with a setup on my Cisco 1700 router, currently im using the router with a business broadband connection and up until now everything has been fine, I have 5 static IP's assigned each doing diffrent things to diffrent server...

eclipse2000 · 08-21-2011

Im trying to configure a Cisco 1801 router. I can access the router fine.Using CCP as a new device i can configure an IP address on FastEthernet0 port and then access the routers config using CCP to setup other things.Once done i click on Save to sta...

eclipse2000 · 08-16-2011

I have a few things setup in NAT on my Cisco 1700 router to allow forwarding to our servers. One of our servers that runs VOIP requires a range of ports setting up. In the NAT settings at the botton where you can select the type and port, Is it possi...

eclipse2000 · 08-11-2011

I have just purchased and setup a Cisco 1700 ADSL router which is working lovely, i have 5 static IP addresses assigned by BT so these have all been configured through NAT and the firewall and remotely we can access our servers etc fine.The proble...

eclipse2000 · 01-25-2012

Hi Rick,There is only going to be 2 remote phones in the remote office and the ADSL connection is quite good so im sure it would be OK passing from site to site on this side of things.As for the policy, nothing is really set in stone for this so i wo...

eclipse2000 · 01-24-2012

Morning Rick,On the 1700 router that had DHCP disabled the 4 VOIP lines come in to the PBX server and then to local phones on the network so as you say it will be coming in to the network on the disabled router then routing through the second router ...

eclipse2000 · 01-24-2012

So could we use the following,10.120.21.x main site10.121.21.x remote siteAt the main site we have 2 1700 routers running 2 connections. One connection has DHCP disabled and this connection deals with incomming mail, outgoing mail to our servers plus...

eclipse2000 · 01-24-2012

Many thanks for your reply Rick.Maybe you could possibly point me in the right direction of where to start, like the programming on the routers for the VPN connection and then assigning the seperate scope. I think the remote site may as well be assig...

eclipse2000 · 12-19-2011

Thanks for the reply, Im trying to use the server 2003 software for the VPN connection, See http://www.techrepublic.com/article/configure-a-windows-server-2003-vpn-on-the-server-side/5805260Towards the bottom it says about needing the following setup...

Member Since	‎08-11-2011 12:57 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	16

User Statistics

User Activity

Connecting 2 sites together

VPN with Cisco 1700 Router

Cisco 1801 Router issues

Cisco NAT setup

Problem with Cisco 1700 Router setup

Connecting 2 sites together

Connecting 2 sites together

Connecting 2 sites together

Connecting 2 sites together

VPN with Cisco 1700 Router