Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have a mail server on which we have two NIC installed one NIC use for public and other one use for private network.
On public network int we have given a static IP which is provided by our ISP and its directly connected with a WAN Router.
On ...
Hi,We are using Cisco wireless controller Model AIR-CT5508-25-K9 in HA Mode. We have two more remote location on which we want to setup wifi from same controller. In remote location we have different VLAN Subnet. So please help us how we can use Wifi...
Hi,We have 4 MBPS Point to Point Link . We are facing link slow issue in our branch. I have also complained to the service provider but they are saying that your link might be over utilized thats why its working slow , but i don't know how to check ...
Hi Rupik,
We dont use any acccess list on WAN router and I am also not very expert about router operation and this router was configured by our ISP.
Please find the attached sho run result for better understanding.
ROUTER#sho runBuilding configurati...
Hi,
It was very simple but we could not get these simple steps from Cisco.We have done the below setting and now we can connect WIFI in remote location through Radius server as well.1) We created a Different SSID and AP Group for remote location and ...
Hi,Today we have tried to connect wifi in our branch office through PSK authentication ([WPA + WPA2][Auth(PSK)] it was working, but when we tried to connect it through radius server authentication (AAA) than its not getting connect. Even radius serve...
Hi, Thanks for your reply,I have already created a different SSID for Site B (example SSID_Site B) and assigned the site B AP to this ssid. Today I will go to my branch and give it a try and will let you know.Question:In branch we are using single V...
Hi thank for your reply.For remote location do we need to create flex connect group or not ??orwe have to just change the ap mode from local to Flexconnect. Also I added remote site vlan in WLC without any IP address because at main site (where WLC I...
