Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am moving endpoints from VCS registration to CUCM registration.
During the testing - I find when I have a CUCM registered endpoint sharing content - the MCU sees the video and content from the endpoint in one stream.
If it is from a VCS registered ...
Greetings All,
This is a strange one - I have a new Cisco Room Kit Plus running ce 9.1.3 75ff735 2017-07-10 code registered to a CUCM running 10.5.2.12901-1.
Intermittently, I am getting the message on the display in the attached picture.
It is usu...
Greetings,
I have a Cisco C60 running TC7.3.6 code connected to a NEC display with 3.5mm audio out of the display to a small amp powering 2 ceiling speakers.
I get a buzz or hum on the speakers. I first thought it was the speakers or amp. But the buz...
We have a setup with many remote locations that all have 4400 WLC's. We have 5508 controllers at several datacenters that act as centralized backup controllers in the event that the onsite controller dies. The AP's at these sites are set up in H-RE...
Hello All,
We have 1 SX80 and have the same issue. I originally thought power, swapped power cables, outlets, all UPS outlets but all other devices in the rack are not rebooting. I upgraded the firmware from CE8.3.4 to CE9.5.0 and still was rebootin...
I did open a TAC case - and at first they thought it had nothing to do with the AI 'Hey Spark' stuff - but in the hidden Experimental that option was turned on.
Turned it off - all good now.
