Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear team,
Currently, I using two Firepowers controlled by FMC 6.2.3.4 and I have two ISP connection into firepower. In my scenario, I want to config dual ISP by WAN1 for user group Admin and WAN2 for user groups MGT. I try to follow the instructio...
Dear All,Currently, I have an ISR4321 in my organization and I want to allow my internal USER to access to internal SERVER with specific port via internet public IP. Can someone help me on this? please kindly check the diagram in attach for more deta...
Dear Supporter,I need you help me to solve this issue. I have a web-server in my office, I want to access to my web server from outside via domain name, so I have registered with Godady by convert my public ip to www.domain-name.com, after that I can...
Dear all,I got a problem with my lab. In this lab there are 1 ASA 5510 (filter internet) and core switch 3560X (for VLAN). I connected and configure the ASA5510 and core switch to each other, as diagram in attachment file, and these device can access...
Dear All,Please help me on this. I have a cisco ASA 5510 with base license and I want to configure on this product as below:1. Interface e0/0 (outside)2. Interface e0/1 (inside)3. Interface e0/2 ( connect to branch with DPLC or local loop vpn connect...
Dear gcheria,Thanks for you reply, currently I have only one connection with one IP public from ISP and I was successful did the NAT to allow from outside to inside_server. But, I need the same by allow my client behind ISR 4321 to access to server v...
Dear Mr.,Thanks you for your reply. Currently I used Ciscco ASA 5512-X version 9.1 firmware. This is NAT which I using in ASA:object network web-server-https host 10.10.17.2access-list outside_acl_in extended permit tcp any host 10.10.17.2 eq httpso...
Dear sir,Thanks for your reply. Now my vlan client can access to internet, the problem cause of NAT on asa. Firstly, I allow NAT to only one range ( VLAN100: 192.168.100.0/24) which I use to connect from core switch to ASA and now I was change NAT to...
Thanks you for your reply. So mean that I no need to enable one more wan on asa 5510 for DPLC connection right? and what about cisco asa 5505 for my branch, it comes with base license also, does it can do like cisco asa 5510?Thanks and Best regard,So...
