Hi.
I'm configuring the Cisco CME with phone Cisco 6911 and Cisco 6921. After end call, i don't hear busy tone. Only is quiet. How can i configure busy tone?
This is config CME. I it rebooted, but it not helped.
version 15.1service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname CME!boot-start-markerboot-end-marker!!no logging monitorenable secret ...
Hi, Adhay !
Thank you.
I saw that link, but there is about PSTN- VoIP calls. I have VoIP-VoIp calls (phone 6911- CME- phone 6921). The voice is good. I can hear voice between phones, but when I put handset on the one phone, I don't hear busy tone?
