Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Issue: I have 1 username within CISCO ISE that I wish to limit to only being able to TACACS into 1 device. e.g. BOB SMITH can SSH / WebUI into device X only.. I have been testing with Policy Sets / Policy Elements. Not sure if I'm on the correct path...
Good Morning All
We have recently setup two Cisco S300V WSA (Virtual)
I have been advised that it's best practice to setup a "Custom and External URL Categories" for Office365 where Authentication bypass is set. This is complete and working.
M...
Thanks for your reply.
The issue is the user report shows as IP addresses and not User (active directory names)
This is because the Office365 traffic is set as Auth Bypass and wont report as a "user"
So the top bandwidth is shown as IP addresse...
