Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two SG220's connected via a single 1Gb trunk. I'm interested in using Link Aggregation to replace this trunk with one that uses 2 or 3 1Gb connections for increased bandwidth.
From past experiments with LAG, I realize that the hash algorith...
I have a Cisco ASA 5505 (512 MB Security Plus) that's currently serving a 20/5 Mbps fiber line with no problems.I'd like to upgrade the service to something faster (75/75 or 100/100) but understand the 5505 has performance limitations. Various accou...
I'm 99% sure the answer is "yes" but wanted to make sure -- can I cascade two SG220-26 switches together? IE, make the two look act like a single 52 port switch?Thanks in advance!
I have a Aironet 1602e in autonomous mode. If I log into the CLI and issue the command "show dot11 associations client" I can see the list of client devices by MAC address. Is there a way for me to configure the Aironet with a name for each device?...
I'm setting up my first ASA 5505 (Security Plus) and want to make sure I'm doing this correctly.I have a web server on my inside network. The web server's internal IP is 192.168.1.53. The web server runs on port 9000. I want this accessible from s...
Thanks for the info.....I figured that was standard switch behavior but wanted to make sure.Thanks also for the auto smart ports tip. I haven't seen this feature or the command in the SG220 docs I've skimmed so far. Its possible its a new feature t...
Ah, I think I may have used the wrong terminology / description. I'm not necessarily looking for the two switches to be managed as a single unit. I just want to connect the 2nd switch to the 1st one and still have all the VLANs work on both switche...
Thanks again for your help!To be clear, I have two client PC's I'm testing with. One on the "inside" VLAN and one on the "work" VLAN.If I take out the first "any", I have to reproduce the rule N times for each of my VLANs. However, even after doing...
