New to this forum. I just updated SG200-26P firmware from 1.0.0.19 to 1.3.7.18 and rebooted. After login, I am asked for new password because "your password has exceeded maximum lifetime". I fill in the required information but it does not work. ...
Hello Aleksandra, Thanks for you answers and details. I will do the factory reset, then install boot code 1.3.0.56 and firmware 1.4.0.88. It may take a while as this switch is critical for operation and not often available for maintenance.When done...
Hello Aleksandra, Thanks for your answer. I cannot look at the settings because I have not been able to connect to the switch and get the logon screen. Last time I connected, a few months ago, it was reporting 1.3.7.18. I see there is a new versio...
Hello Dorian, The issue has not been resolved yet. I came to the conclusion that it needs factory reset. I just need a suitable time to do it. Since a while, I cannot even connect to it with the ip address. There is also another problem, not sure ...
I had a similar issue after an upgrade 4 monts ago (see 12172586, Cannot change password after SG200-26P firmware update).Did you try to use the default user/password (cisco, cisco)? Did not work in my case.My problem is not solved yet. I still hav...
