Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm trying to figure out the best way to accomplish this. I've got to locations, each has a separate subset of VLANS used for management, voice data wireless, and wireless management. There are 4500X w/ IP services in each building connected to e...
I'm trying to get my switch to pass authentication for desktop to NPS(Server 2008R2.)I do not need to have any port security just need it to authenticate so that the internet filter will pickup on the local user via accounting.Most configurations I s...
Hi, I've taken your advice in to account, I've enabled OSPF on the switches, and changed the connecting links into routed ports.
Here is an updated diagram.
I've set the outbound port on swit1 and the next hop to be Area 0
My plan was to make the i...
Thank You Marcel,
That is correct building 2 uses wan from building 1.
The reason for the layer 3 between buildings is to cut down on the broadcast noise, and I agree that OSPF would be a better way of connecting the two.
I'm going to spin up some ...
So here is what I have now:aaa new-modelaaa authentication dot1x default group radiusaaa authorization network default group radiusaaa session-id commonradius-server host xxx.xxx.xxx.xxx auth-port 1645 acct-port 1646 key $$$$$dot1x system-auth-contro...
