Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attempting to set up the FastEthernet management port on some 4500x switches that we have recieved for Out-of-Band management, but I am unable to get them working. I have set this up before on ASR1004 routers and have not had any troubles with ...
Can the Catalyst 9000 series switches use Cisco Smart Software Manager On‑Prem (SSM On‑Prem) for license management, and if so, what is the recommended switch configuration to support this?Additionally, with Smart Licensing Using Policy (SLP) now bei...
We finally got the out-of-band management interface working by upgrading the IOS from 3.4.4 SG to 3.4.6 SG on a new 4500X that we just received. Thanks everyone for your help.
No, I have not been able to find a solution for this. As it is I am unable to use the management port on my 4500-X switches for out-of-band management.
I was testing the 172.16.0.0/16 block when I had the management port directly connected to my laptop. When it was connected to the switch it was using a different IP block and the gateway to that block is on a router that is also connected to the ot...
Unless that enabled by default now I have not enabled anything on this switch besides this management port. I even erased the startup-configuration and started over with just this setup. I wanted to get the management port working so that I could set...
