Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Cisco Firepower 1120 NGFWFXOS: 2.10(1.75)FTD: 7.0.1-84Managed by FDM onlyI cannot access FDM web interface or SSH on the physical management1/1 interface. I can only manage it through the data interfaces which is fine but I want to setup up HA a...
I have a cisco WS-C3750-48P (factory default config) that I have connected to a device ( AM335x processor board ) when I try and ping the device from a laptop also connected to the switch I can see the arp request sent to the board and I can see an a...
The cisco ASA 5512-X we have recently purchased comes with an out of date ASDM-IDM. It comes with version 6.6(1) which is not compatible with the asa version 9.1 is this normal?
I'm afraid you are wrong my friend, https://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/fp1100/firepower-1100-gsg/ftd-fmc.htmlBy default, the Management 1/1 interface is enabled and configured as a DHCP client. If your network does n...
No the management1/1 interface is default set to get an ip address from DHCP which I don't have to test with, if I give it a static ip address I cannot access the FDM web interface if I am on the same subnet as stated.
I cant see anything I have tried all sorts of debug commands, which one should I use? There is also no errors or drops in the show interface command! This device works fine on other switches just not on Cisco's
