Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following configuration (as shown in the diagram below)My Anyconnect user connects to data center 1, but in the event that data center is not available, he should connect to data center 2. The problem I have is two fold:1. My Anyconnect us...
Here is my problem:I have 2 ASAs (5515-x) in a passive fail over configuration.I have a Comcast internet connection with two static IP addresses (one for each ASA) coming in on a single fast Ethernet port.I am told that I need to have a switch to tak...
With one connection from the Comcast box, we can only connect to one ASA, but that does work. We need the switch to break out the second connection to the second ASA.We haven't used that switch elsewhere, but we did use another switch in its place an...
In my initial configuration, I did have the three connections in their own VLAN. When I found that I had no connectivity, I removed all the configuration except the port configs, just to see of that was the issue. Once I get this working, I will plac...
