Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,I need to confirm something.With the WS-X45-Sup6-E supervisor engine, is it possible to use one of the uplink ports with the X2 optics for 10G speeds and the other port with a Cisco Twin Gigabit Converter Module so as to have 2 1Gb ports...
I'm trying to connect a HP c7000 blade enclosure with a Catalyst 3750 switch. The c7000 enclosure came with 2 HP Virtual Connect FlexFabric 10Gb/24-port Modules.This is what i have:Cisco side:-cisco catalyst 3750 10/100 with four 1Gig SFP ports-1 Cis...
Hi,Just figured out the Supervisor Engine is: WS-X4013+ Supervisor Engine II-Plus.Apparently this doesn't support 10Gb line cards from my research. If i'm correct, it then means i'll have to acquire a 10Gb equivalent. I came across this one from my r...
@Bilal,That is crystal clear, i see the picture now.Well, scaling down the Virtual connects on the c7000 enclosure to 1Gb speeds would really be under-utilizing the capabilities of virtual connect and will eventually be a bottle-neck later on when th...
Thanks for your reply!The Cisco 1Gig SFP works fine when used in a Cisco-Cisco fiber connection.For the HP 10Gig SFPs i momentarily tried a loop connection between the two virtual connects and the sfp links lit up just fine, so all SFPs and fiber cab...
