Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody - I reset my Cisco 2911 ISR to the factory defaults. I then used the configuration guide to do the initial set-up through the CLI. I was able to assign IPs to the GE0/0 and GE0/1 ports. Now I cannot access the GUI device manager at al...
Hi Reza - Thanks for the help, I really appreciate it.I followed the link you provided, and I see that the page it goes to is in the Unified Communication section of the Cisco website. Does this apply to a router that isn't doing anything other tha...
