Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am trying to set up a new vpc between a pair of nexus 93180 and nexus 3172I was planning to set it up as trunk with no vlans allowed (switchport trunk allowed vlan none) so that I can add vlans once the port channel is up, however it bounces up ...
I seem to have conflicting information about the values I should use for the BC value when policing in the following two cisco links
http://www.cisco.com/c/en/us/td/docs/ios/12_2/qos/configuration/guide/fqos_c/qcfpolsh.html#wp1012025
http://www.cis...
there are 2 93180 connected to 2 3172, one port per device, 2 links. after so many failures the 3172 disables the interface2021 Mar 3 11:06:07.244 SYD1-SW-TOR-B-01 %ETHPORT-5-IF_DOWN_ERROR_DISABLED: Interface Ethernet1/40 is down (Error disabled. Rea...
thanks, however I understand that when policing or shaping the CIR is the rate you want in average per second, say you want 10Mbps on a gig interface that means you will send 10 Mbits of information on one second. As you are sending it on a gig inter...
Hi Leigh I was wondering if you can post your comments after you tried setting this up in the 7200.I am running ver 12.4 and can't get much information around, however I found a couple of posts saying the feature is not supported. any comments would ...
