Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
Just experimenting on my home router.
I wanted to see if EEM can send a email to my mail provider using standard port 25.
For the test, I trigger on a IPSEC VPN coming into my router and a syslog message pattern that you can see below.
My in...
Hi KeithI will use the Cisco community as a repository for my answer to your question on event manager. Gotta admit I am not using the most current version of router IOS. Cisco IOS Software, C800 Software (C800-UNIVERSALK9-M), Version 15.3(3)M, RELEA...
Hi keithI will use the cisco community to answer your question. dynamic dns are now going to charge for the dynamic dns resolution. So an alternative is to grab one free Dynamic DNS host account at www.noip.com Here is the cli that has to be incorp...
Hi AllA friend asked me to place a CLI section for the ISR881W for dynamic dns to noip.com dynamic dns are now going to charge for a dns address. So an alternative is to grab one free Dynamic DNS host account at www.noip.com Here is the cli that ha...
Thanks Joe for the informative email, you are spot on.
But today there is a work around is to have EEM send a email using no authenticaton. ..ouch
For folks that are trying to get their router to send an email on a syslog-able event, a work aroun...
Hi keith, There must be a bug or I screwed up , the Commands work most of the time, but I have noticed where the switch port didn't enable occasionally...I as forced to delete the script as it must work perfectly.
Hi kris dont see any access list entries mentioning UDP.test to see if access list is the issue , by removing the access list from fastEthernet 8no ip access-group wan-in indo this for a couple and see if you can then access the DVR. regard Dave