Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I' d like to have some support for a very-basic PIX firewall configuration.I 'm dealing with PIX 515 's inside/outside/dmz zones.Inside hosts can ping inside interface , outside hosts outside interface and so on....I cannot ping outside int...
Hi everybody, I'd like if someone can confirm me these points related to Cvoice 642-436 exam ( especially from whom already took te exam).a) there are no QoS questionsb) there are no Lab question ,or at least one scenario could be inserted.thanks f...
Dear Genedeath, I have noticed that you posted this message since last year ..... have you ever been able to solve the case??I had a glance to the diagram and it looks quite similar to my case.I need to configure a Cisco MWR2941 for the very first ...
The configuration was correct. host1 can ping host2.I was only wrongly testing cause i was referencing outside interface, that , as you said never answers to ping. Thanks for the support!Mauro
Your drawing is a good idea and useful to undestand the matter. I try to track again your approach : in my case host2 (20.1.1.1) can ping inside( 20.1.1.2) ........ ok!! host1(10.1.1.1) can ping outside(10.1.1.2) ........ok!! I c...
Dear Varun, thanks for the reply I'm not dealing with ASA , but with a Pix515 : i tested that outside interface replies to ping ( from outside hosts) and I've read in a Pix firewall book that it would be possible to test connectivity from inside ...
