Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking for help with a certain issue... We have 2 circuits into our location, 1 for data side and 1 for VoIP. Currently - the data side is used a failover for the VoIP but we need to manually fail them over when the MPLS goes down. Is it possible to...
We have 3 different models of Access Points in our organization:AIR-AP1262N-A-K9AIR-AP1231G-A-K9AIR-AP1242G-A-K9We need to move our security from WEP to WPA2 but need to make sure all 3 APs can support it.When in the GUI, I have a hard time believing...
Jody, thanks for all your help! One more question...Wouldn't this route (below) continue to push traffic out that interface?ip route 10.160.230.11 255.255.255.255 10.93.254.17 permanentOr would the lower metric "track 1 route" take care of that route...
I have attached both configs for the switch and the MPLS router...This is what I came up with for proper config....Am I correct?ip sla 1icmp-echo 10.160.230.11 source-ip 10.93.254.17frequency 10ip sla schedule 1 start-time now life foreverdelay down ...
After reviewing IP SLA, I have 1 major question...How do I configure the SLA on the MPLS/VOICE side while keeping our data through the Data ISP/MERAKI?I hope that's clearly worded...
Thank you very much for the response! This particular switch only has a few static routes. We are not redistributing routes through any dynamic protocol. It looks like IP SLA's are what I need to look at.
Guys, is this still the case? Have any changes been made in the 7 years since this ticket? We are looking to use our ASA 5505 as an NTP server but everything I read says NO....