Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i have a site to site IPSEC tunnel between two ASA.Site A has dual ISP configuration (SLA tracking) but site B has single ISP.i have created a failover tunnel between site A & B. When tunnel is on primary link, i can successfully ping LAN (site...
Hi All, I have one ASA5520 which has no image & have refused to load image using TFTP through ROMMON.I have tried multiple image files & using different TFTP server. It always end up giving me check sum error at launch after transfer. I have another ...
Hi,ASA5520 has boot problem, it always stuck at booting process, with no response. I have tried updating image file using ROMMON but it always fails on Checksum verification on install image failed. tried with different files but no success.. Any sug...
Hello Guys, Any suggestions... I am stuck as ASA isn't accepting any image. !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!Received 24809472 bytesLaunching TFTP Image...Cisco Security Appliance admin loader (3.0) #0: Fri Aug 30 19:48:50 PDT ...
i have tried multiple imaged downloaded from cisco only..847,843,901,903 etc.. but all has same problem.I have checked checksum with cisco & all are correct...
All process followed are correctADDRESS=SERVER= No gateway as both machine are connected through cross overPORT=IMAGE=tftp after this as you will notice, it will start copying file but at end when its time to load new image file, it give checks...
