From the cisco configuration guide;Perform this task to enable the DHCPv6 relay agent function and specify relay destination addresses on an interface. SUMMARY STEPS 1. enable 2. configure terminal 3. interface type number 4. ipv6 dhcp relay dest...

Hello , I am trying to setup nat-pt so that an ipv6-only network can communicate with an ipv4-only network and vice-versa..I have followed the cisco ipv6 configuration guide and the following link http://cciethebeginning.wordpress.com/2009/07/27/ipv6...

Hello , I am trying to setup nat-pt so that an ipv6-only network can communicate with an ipv4-only network and vice-versa.I have followed the cisco ipv6 configuration guide ''Enabling Traffic to be Sent from an IPv6 Network to an IPv4 Network without...

Hello,i would like to get some help on how to make a cisco router supplies addresses to different subnets connected to fastinternet interfaces using "dhcpv6"?here is my attempt, which is not working;enconf tipv6 unicast-routingipv6 local pool VLAN10-...