Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I have a scenario wherein, there are 2 cores are connected together via a layer 2 trunk. Has two VLAN between the two cores I.e. core to core subnet a /28 and a /24 VLAN which is the infra VLAN.
Infra VLAN:
VLAN 100
ip address 10.12.1.254...
Hello All,
I have a scenario wherein, there are 2 cores are connected together via a layer 2 trunk. Has two VLAN between the two cores I.e. core to core subnet a /28 and a /24 VLAN which is the infra VLAN.
Infra VLAN:
VLAN 100
ip address 10.12.1.254...
Hello All,
I have a scenario wherein, there are 2 cores are connected together via a layer 2 trunk. Has two VLAN between the two cores I.e. core to core subnet a /28 and a /24 VLAN which is the infra VLAN.
Infra VLAN:
VLAN 100
ip address 10.12.1.254...
Hey Marvin,Can you help me with this basic configuration. I cannot reach the internet with my current setup of access-list, NAT, and static command.The configuration are as follows:SFRA(config)# sh run | i access access-...
Hi Eurosigma,Can you post your configurations? As in I am specifically looking for object network configs. I have NAT, access-list, and static route in place. Yet not able to reach the internet. Did you not have it configured at all? I tried using th...
Hi Eurosigma,Can you post your configurations? As in I am specifically looking for object network configs. I have NAT, access-list, and static route in place. Yet not able to reach the internet. Did you not have it configured at all? I tried using th...
