Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just connected two new Cisco SIP phones, before we did not use sip phones on our network. When I try to call on PSTN using these sip phones through MGCP gateway its not working but from the SCCP phones its working fine.
I want to replace VS-S2T-10G what procedure should I take?
should I remove the flash memory and connect it with the new SUP2T will it work? or I have to configure it through console.
I have 2 Cisco Catalyst 6807-XL Switch and they both have VSS between them. I am facing some problem in one switch and want to take backup of that switch only.
When I connect with console it gives me Virtual CLI, how can I get CLI for individual swit...
Yeah the topology is IP Phone --> CUCM--> CUBE/GW (MGCP)
Active Load ID: sip88xx.11-7-1-17Inactive Load ID: cert.os.mfg.dropDownload Status: FailedRequested Load ID: sip88xx.10-2-2-16
The scenario is that we have hotlines configured on the phone...
Check if there is any rouge DHCP there in the segment people usually use the VMware in there pc and it has a built in DHCP and that causes the problem. because I went through a similar issue sniff the packets with wireshark check if there is a NAck p...
