Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
set the port speed to 10 and duplex half and try both cables again. also if you have a hub handy you can use it for troubleshooting, plug both devices in, the goal would be to try and get link lights.also note your E0 and E1 are not 100Mb devices s...
ok i see there are some slips, this can be caused if both sides of the circuit are set to line. please set on side to internal."service-module t1 clock source internal"then do a clear "service-module x/x" which will force a reset of the card. then...
Hi, i know for sure the cpu on the 3640 is weak... my recomendation is any interface that has high errors on it are causing the high high i/o. the errors on the T1's may be due to clock drift, clock source or other carrier related issues.can you...
rlcarr you may be incorrect.the newer V2 wic is not recognized in the older 2600 routers. both the original wic-1dsu-t1 and wic-1dsu-t1-v2 work in the 2600xm line.of course this info may have changed since your post date. knowing cisco they probably...
