Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have wap321 config and cat 2960 as attached.
my issue is, if I configure native vlan160 on trunk,I lost the ping and web gui to wap321 although I have assign management vlan on wap321 to vlan160
and uncheck untagged vlan.
is this a normal behavi...
Dear All,
please have to advise on below.
Our client just purchased ISM-SRE-300-K9. but I noticed that no CUE was installed on the module when I power up the router.
I sourced for 8.6.10 and ran the installation since 09:30 am without getting to kn...
Hi All, I've just completed configuring CME 10.5 (c2900-universalk9-mz.SPA.154-3.M1.bin) on 2901.All are working except the speed dial.When I press speed dial button. it Shows - Key Is Not Active on the screen.But, If I insisting on pressing it, it d...
Please help and suggestion on below point.I'm configuring vlan 3 on port 3 on firewall but is not pingable although I connect directly to the port.My goal is from my PC 10.10.10.X can access internet through vlan3 10.10.10.250. Here is my Firewall co...
Hi Mohammed.
Installation was completed. half way I guess.
!
interface ISM0/0 ip unnumbered Loopback0 ip virtual-reassembly in service-module ip address 10.1.10.1 255.255.255.252 !Application: CUE Running on ISM service-module ip default-gateway 10....
Hi Mohammed,
My bad.
I configure the wrong IP. apparently .252 was already i used.
this is the current configuration now.
!
interface GigabitEthernet0/0 ip address 192.168.14.253 255.255.255.0 duplex auto speed auto!interface ISM0/0 ip unnumbered Gi...
Hi Mohammed,
I've changed the ISM setting as below
!
interface ISM0/0 ip unnumbered GigabitEthernet0/0 ip nat inside ip virtual-reassembly in service-module fail-open service-module ip address 192.168.14.252 255.255.255.0 service-module ip default-ga...
