Vignesh M

If I configure 2 VSL links between VSS, what would be its behaviour?Whether the redundant VSL link w...

I suspect your R4 uses a single ospf process, but if you want to try another variation, use two OSPF...

Thanks for the replies. Yes Joe. My R4 is having single ospf PID. Now I want to reitrate the point t...

As per my knowledge routes of one standard area will be shared with other standard area using backbo...

Hi Joe, Please clarify the below points.VSS won't send flows across the VSL unless it must.Vignesh

Scenario:I have configured VSS in distribution Layer(Sw1 & Sw2). There is 1 L3 port configured for t...

Can someone explain the usage of the below command in brief.sh config | s ospf

TFTP via Management port is not working correctly. Please suggest. I have done the following things....

Hi, I dont have enough memory in flash memory as the existing corrupted imaged occupied most of the ...

I tried upgrading CISCO 4507R switch Image. Because of corrupted image, the IOS is not booting. Now ...

Thanks all for making things clear :-) 

Hi, thanks for the inputs and clarification. Another doubt popped up. If I have a switch and have 4 ...

When will a packet get tagged?I have attached 3 network architecture diagrams(Image 1, 2, 3). Config...