Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having issues with Catalyst 2960 Switch Console. Switch boots up fine and the process shows up on the console. But after the boot-up, console stops responding. It also does not respond to Break sequence at the boot-up. Any solutions? I am using ...
I am using dynamic natting in packet tracer. But packet tracer does not seem to support "ip nat inside/outside destination..." command. Can anyone confirm this?Thanks
Traffic is flowing. It just does not accept input from console. Although it shows output from switch in console like when interface goes up or down. And console settings on switch are default. Console was responding fine, it just stopped working out...
