Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I need to change the MAC address on a physical interface of my switch.
The command is not aviable in the interface configuration mode.
The switch is model is :
Switch Ports Model SW Version SW Image Mode------ ----- ----- -------...
Hello everyone,
I'm currently working as an internet service provider.
I'm facing an issue with ARP request I think.
Here is the diagram :
Each client router has a default route, to their respective gateway.
Client 1 and 2 have 192.168.0.1
Client...
Hello everyone,
I have a little question about an architectural design for the network i'm managing.
Actually, we use two stack of 3*3750-X (using 2*10Gbits/s interconnection) as core, and 4*2960-X as access.
All those switch are in the same room.
...
Hello everyone,
I recently had some issues with output drops, and i'm planning to re distribute the physical connections per asics cards.
But i was wondering about the switch performance itself.
I use 3750X-48T-E stacks, and i looked on the datashe...
Hello !
I have a question about monitor sessions and 2960X switches.
I already configured monitor sessions with ip filtering by access list on 3750x switches.But on my 2960X, i dont have the option to filter by an access list.
I'm using IOS 15.0(2)...
Hi Paul,
Thanks for your help.
Correct me if i'm wrong, but this command is for creating a static entry in the mac address table.
So it says "to join this mac address, go through this interface" right ?
I need the switch to use a specific mac addre...
Hi again guys,
A little update about my troubleshooting.
I've used arp debug on switch2.
Switch2 is able to receive ARP request from client, and send response to them.
The client does not receive the ARP response because Orange filter mac adress....
Hi guys, thanks again for the help.
@Rafael Carvallo You were right. I've checked our contract with Orange, and we have VPLS service.
Here is the full diagram :
Before getting to the backbone router, those ARP have to pass two switchs.
So my prob...
