Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Give your computer the 10.0.0.1 (subnet 255.255.255.0) ip address. make sure it is on the same network as the access point.start i.e. tftp_32 and point it to the directory which contains the image file.on the console type:set IP_ADDR 10.0.0.2set NETM...
(from lightweight recovery image)-The debug capwap methode did not work due to the forced dhcp option.-type:enpassworddebug capwap console cliconf tManual bootexitreload (confirm)did the trick. send ap3g2-k9w7-tar.152-4.JB5.tar using your favorite t...
That did no do the trick. Both are lightweight. I tried them both without succes.The story of a unified image is not true i think. If it was true you should expect at least some line of text in the release note about this major change.But i find out...
That's not working for this new concept (of a single unified image). There must be a command or so to toggle between autonomous and lightweight...available commands in enable mode:Exec commands: access-profile Apply user-profile to interface capw...
