About sgrizzle

sgrizzle · 10-08-2003

I need to ping a set of remote hosts to determine connectivity. I want to use object-groups to limit the number of commands used. I have the ICMP group set for echo-reply, source-quench, unreachable, and time-exceeded. I also have a network object...

sgrizzle · 08-01-2003

Lab set up. Back-to-back Cisco routers through Serial ports. (with the correct serial cables). Both routers rev. 12.2 (T). Laptop connected to ethernet port on one side, rest of network (including Internet access through PIX 506E) on the other side...

sgrizzle · 10-11-2003

So it looks as though the access-list statement is where I am in error. Please tell me if I am reading this correctly..."access-list 101 permit icmp object-group mydestination any object-group icmp-allowed" translates to "permit icmp from mydestinat...

sgrizzle · 10-10-2003

I'm just not getting the replies, and the network is up. (By the way, would it complicate matters if this was through a VPN tunnel? It is. However, my users are getting their traffic through the tunnel and I can see that it is up and running.)Yes,...

sgrizzle · 08-04-2003

Mark's 'default route' pointing to the PIX was right on! Can he give an explanation as to why?

Member Since	‎08-01-2003 02:34 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	5

User Statistics

User Activity

Using Object-Groups in a static

Ethernet Encapsulation Failure

Re: Using Object-Groups in a static

Re: Using Object-Groups in a static

Re: Ethernet Encapsulation Failure