Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thank you very much !!One last question: Lets assume that the only MTU configuration in the IOS side is "mpls mtu 1508"I assume the XR side should look as follows:interface Gi0/3/2/3 mtu 1522interface Gi0/3/2/3 ipv4 mtu 1500 -> i want to limit max ...
configuration looks correct !!! Just dont forget to add a route-policy inbound and outbound in XR for eBGP connections, otherwise you wont receive nor propagate routes. neighbor 10.187.227.2 remote-as 65505 address-family ipv4 unicast route-polic...
yeah.. forget it, that command is just for L2TPv3 (i forgot) .... Try to make sure what is the best practice when using an interface vlan as the source, i never used it (maybe will lab it soon) This status appears when the physical link is up/down or...
I never saw a L2VPN using a SVI.... Try to create a pseudowire-class on both sides, and use the loopback f both as source address for this connection (of course, if the loopbacks are reachable between each other)somethink like... (i dont have a route...
