Hi, I'm struggling with running a SNMP Walk against a SG500-28P stack. I wish to retrieve: CPU Utilsation Mac-address table count Port Cahnnel utilisation. Switch Stack member state  When I run the walk using 1.3.6.1 all I get is basic system info...

I have created at LAG across a stack of two SG-500-28P devices which go to a 3750-E switch stack:However when you unplug one of the Etherchannel members the SG500-28P appears to trigger off a STP convergence and the link goes down. To be clear here t...

Has anyone had any experience stacking the SG500-28P switches using 1Gb single mode SFP's and Single Mode Fibre.Each switch in the stack would be 500 Meters apart with a longer stack link back to complete the Stack ring.thanks 

I have the following EEM config:event manager applet EEM_BGP_DOWN  event syslog pattern "%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback100, changed state to down"  action 1.0 cli command "enable"  action 1.1 cli command "configure term"  ac...